Showing 0–10 of 612 results

The RAM-VP-TTM8-1U, combination swing arm/tele-pole system, will connect to any RAM vehicle base with a welded female tele-pole. Included is a 8" tele-pole that can be easily adjusted by turning the knob at the top of the post. The length of the double swing arm is 12". The open socket of the swing arm will accept mounting bases with a RAM 1.5" diameter ball, enabling a versatile RAM ball and socket system. The bolt pivoting point allows a complete 360 degree rotation and the ball and socket system allows a 180 degree vertical pivot with a 360 degree rotation.

The RAM-B-189BU consists of a double 3.3" twist lock suction cup base. Included is a hole pattern that will allow attachment to all RAM bases that contain the universal AMPs hole pattern.

The RAM-235U consists of a double U-bolt base with 1.5" diameter ball and two stainless steel u-bolts. The double U-bolt base will accommodate rails from 1" to 1.25" in diameter.

The RAM locking knob, includes a brass 5/16"-18 thread, for 1.5" socket arms; this allowing you to disengage the screwing of the knob. Once you have set your mount in the location you need, you can lock it in place and feel safe that your mounted device will stay right where you left it.

The RAM-D-201U-C, short double socket arm, has a socket at both ends that accommodates 2.25" ball bases. A single spring inside the arm opens the end sockets, allowing you to pivot the ball and socket connection. This socket technology allows for almost infinite adjustment and perfect viewing angles.

The RAM-201U-BL, standard double socket arm with small size locking knob, has a socket at both ends that accommodates 1.5" ball bases. A single spring inside the arm opens the end sockets, allowing you to pivot the ball and socket connection. This socket technology allows for almost infinite adjustment and perfect viewing angles. The locking knob, includes a brass 1/4"-20 thread; this allowing you to disengage the screwing of the knob. Once you have set your mount in the location you need, you can lock it in place and feel safe that your mounted device will stay right where you left it.

The RAM-D-246U-IN1 consists of a 2.25" rubber ball, connected to a 4.75" square plate with 4x100mm holes and 4x75mm holes in each corner.

The RAM No-Drill laptop mounting base features a heavy-duty steel mounting base with a universal design to fit a variety of vehicles. Using the passenger side seat rail bolts as attachment points, existing hardware is used to secure the laptop mount base in the vehicle. Will this mount install in your vehicle? Learn more by following the steps in this document: Universal Vehicle Laptop Mount Compatibility Guide

The RAM-D-202U-IN1 consists of a reinforced post, 2.25" diameter rubber ball, connected at right angles to a 3.68" diameter round base. The base has pre-drilled holes, including two holes at 180 degrees and three holes at 120 degrees.