Showing 0–9 of 9 results

The Parallel 1284-B Interface Card installs into the printer's internal port. It supports a parallel 1284-B compliant interface using a 36-pin D-shell female, bi-directional connector. It is recommended that a Lexmark 10' Parallel cable (P/N 1021231) or a bidirectional IEEE 1284 complaint cable be used to avoid compatibility problems. See the Technical Reference for more information about the parallel interface.

Freedom Place assets where they are needed - Printer location is functionally and economically driven, not constrained by existing LAN connections. Easy Setup Wired and Wireless Configuration - Configure using a USB cable or without any cables. A print server to connect to most major wireless networks via the 2.4Ghz band using one RP-SMA connector with antenna. Embedded Web Page The embedded web page allows administrators to flash update printer firmware or access printer settings using a web browser to monitor printer status and change default settings easily. Network Communications Security SNMPv3 supports encrypted and authenticated management traffic protecting remote configuration and device status messages.IPSec can be used with both TCP/IP IPv4 and IPv6 networks and provides encryption and authentication of communications at the network layer.

Lexmark 256MB DDR2 Optra Lexmark International, Inc. is a leading developer, manufacturer and supplier of printing solutions -- including laser and inkjet printers, multifunction products, associated supplies and services. This memory module holds 256MB of data.

128MB memory module

512MB memory module

E460, E462 Card for IPDS/SCS/TNe

The RS-232C Serial Interface Card installs into the printer's internal port. It supports a standard RS-232C interface using a 25-pin D-shell female connector.

The RS-232C Serial Interface Card installs into the printer's internal port. It supports a standard RS-232C interface using a 25-pin D-shell female connector.

The RS-232C Serial Interface Card installs into the printer's internal port. It supports a standard RS-232C interface using a 25-pin D-shell female connector. For use with Lexmark printers that contain an open slot. -Configuration settings for the serial interface are available using the Serial Opt Menu from the printer's operator panel. Baud rates from 1200 to 115.2K are supported. -Baud rates:1200, 2400, 4800, 9600*, 19.2K, 38.4K, 57.6K and 115.2K; 7 bit or 8* data bits; Parity - Odd, Even, None*, Ignore; Start and Stop Bits; DSR/DTR Data Flow control with DTR pacing, DTR/DSR, XON/XOFF, XON/XOFF/DTR, or XON/XOFF/DTR/DSR flow control protocols. -RS-422 is not supported. -See the Technical Reference for more information about the serial and parallel interfaces.