The loudspeaker shall be a surface mount, two-way, full-range system, with an internal passive crossover. The loudspeaker's low-frequency transducer shall be a 5.25"" (133 mm) woofer, with a weather resistant polypropylene cone, and a 1"" (25 mm) voice-coil. The loudspeaker's high-frequency transducer shall be a 0.75"" (20 mm) Ferro fluid cooled driver, coupled to a baffle-integrated waveguide. The loudspeaker system shall meet the following performance criteria: Power handling, 75 W of IEC 60268-5 continuous pink noise (6 dB crest factor); Frequency response, 55 Hz - 20 kHz (-10 dB from rated sensitivity); Sensitivity, 89 dB at one watt, 100 Hz - 10 kHz at one meter; Impedance, 8 Ohm nominal, 6.5 Ohm minimum. The loudspeaker shall have a transformer suitable for use on 70 V or 100 V distributed lines. The transformer shall have taps ranging from 7.5 W to 60 W, plus an 8 Ohm bypass, selectable using a switch on the rear of the enclosure. The 8 Ohm bypass selection shall be protected by a safety screw. The high-frequency transducer shall drive a waveguide to cover evenly 90° horizontally by 90° vertically. The finish shall be black (RAL 9004) or white (RAL 9003). The grille shall be marine grade aluminum. The loudspeaker shall be adjustable over a range of 90° vertically, using a U-Bracket. The loudspeaker shall have an included U-Bracket. The U-Bracket shall be marine grade aluminum. Electrical connections shall be through a 4-pin detachable Euroblock connector on the input panel. The loudspeaker should include an IP65 weather cover for the input panel.
The loudspeaker shall be a surface mount, two-way, full-range system, with an internal passive crossover. The loudspeaker's low-frequency transducer shall be a 5.25"" (133 mm) woofer, with a weather resistant polypropylene cone, and a 1"" (25 mm) voice-coil. The loudspeaker's high-frequency transducer shall be a 0.75"" (20 mm) Ferro fluid cooled driver, coupled to a baffle-integrated waveguide. The loudspeaker system shall meet the following performance criteria: Power handling, 75 W of IEC 60268-5 continuous pink noise (6 dB crest factor); Frequency response, 55 Hz - 20 kHz (-10 dB from rated sensitivity); Sensitivity, 89 dB at one watt, 100 Hz - 10 kHz at one meter; Impedance, 8 Ohm nominal, 6.5 Ohm minimum. The loudspeaker shall have a transformer suitable for use on 70 V or 100 V distributed lines. The transformer shall have taps ranging from 7.5 W to 60 W, plus an 8 Ohm bypass, selectable using a switch on the rear of the enclosure. The 8 Ohm bypass selection shall be protected by a safety screw. The high-frequency transducer shall drive a waveguide to cover evenly 90° horizontally by 90° vertically. The finish shall be black (RAL 9004) or white (RAL 9003). The grille shall be marine grade aluminum. The loudspeaker shall be adjustable over a range of 90° vertically, using a U-Bracket. The loudspeaker shall have an included U-Bracket. The U-Bracket shall be marine grade aluminum. Electrical connections shall be through a 4-pin detachable Euroblock connector on the input panel. The loudspeaker should include an IP65 weather cover for the input panel.
Customizable AniMe Matrix™ Displays Cutting-edge AniMe Matrix™ displays on each ear cup feature mini-LEDs that can be programmed to show off your style with custom lighting designs, unique animations and live audio visualizations. Soundwave Light Effects Exclusive Soundwave light effects make lights flash in sync with the sound of your voice. You can activate the effects via the control switch on the ear cup, and you can choose your favorite colors via Armoury Crate software. High-Resolution ESS 9281 Quad DAC™ The ESS 9281 Quad DAC™ contains four digital-to-analog converters (DAC) that provide lossless audio processing. There's a DAC for each frequency band — low, mid, high and ultra-high — for clearer sound, and an unparalleled 130 dB signal-to-noise ratio (SNR). With ROG Delta S Animate, you can hear every detail and enjoy crisp, clear sound for a true-to-life audio experience. Built-In MQA Renderer Master Quality Authenticated (MQA) is an award-winning audio technology that delivers studio-quality sound and reveals every detail of the original recording. The ROG Delta S Animate headset can connect to an MQA core signal, which is used by global streaming service apps such as TIDAL, to complete the final 'unfold' of an MQA music file and provide incredible audio quality. High SNR in FPS Games A high signal-to-noise ratio is critical for gaming headsets, especially in FPS games. A higher SNR allows you to precisely pinpoint the origin of enemy footsteps, or hone in on the location of gunfire or explosions on the battlefield. With its ESS 9281 Quad DAC™ design, ROG Delta S Animate is capable of achieving an unprecedented 130 dB SNR, unrivaled by single DAC headsets. Crystal-Clear Highs and Punchy Bass The exclusive ASUS Essence drivers are mounted in airtight chambers for clearer, richer audio. These high-resolution drivers feature a wide frequency response of 20–40 kHz to provide incredibly strong bass and optimized gaming audio, so you'll hear every detail while enjoying an all-around immersive acoustic experience. Exclusive Hyper-Grounding Technology Exclusive ROG Hyper-Grounding technology uses a multi-layer printed circuit board and a special layout to prevent electromagnetic interference, ensuring that all you hear is pure, noise-free audio. ASUS AI Noise-Canceling Microphone The ASUS AI Noise-Canceling Microphone (AI Mic) has a dedicated processor that’s designed to reduce over 500 million types of background noise while preserving vocal harmonics for crystal-clear in-game voice communication. Common background noises such as chatter, keyboard clatter and mouse clicks are reduced by up to 95%. Multi-Platform Compatibility The USB-C® connector and included USB-C® to USB-A adapter cable* provide compatibility with PCs, Macs, PlayStation® 4 and 5, Nintendo Switch™ and mobile devices. *Included USB-C® to USB-A adapter cable enables connection with PlayStation® 4 and 5 and Nintendo Switch™ Crafted for Comfort ROG Delta S Animate is exceptionally lightweight at only 310 grams. Ergonomic D-shaped ear cups closely match the shape of your ears to reduce unnecessary contact areas by up to 20%, and a sloped design provides better comfort and also helps improve sound quality by channeling audio directly into the ear canal, tilting the drivers at a 12° angle. Two Types of Fit and Feel Two ear cushion options: ROG Hybrid Ear Cushions Made of protein leather and fabric mesh, they are perfect for long gaming sessions, offering a contoured fit, with material that is thick but breathable. Fast-Cooling Protein Leather Ear Cushions The cushions are made of 100% protein leather and fast-cooling memory foam to give unbeatable comfort with thinner and softer material. Tuning and Customization Made Easy Instant Control at Your Fingertips Intuitive control buttons on the ear cup let you instantly control volume, mute the microphone or adjust AniMe Matrix™ lighting during gameplay. Armoury Crate Armoury Crate software offers extensive controls and an intuitive UI, so you can easily adjust the audio profile and lighting effects. *Virtual surround sound is only available on compatible devices or via Armoury Crate software.
Cutting-edge image processing technology for extraordinary visual experiencesThe ZRCT-300 is a dedicated display controller for Sony's modular Micro LED large display system. One ZRCT-300 unit can control up to 64 ZRD-C12A/ZRD-B12A cabinets or 100 ZRD-C15A/ZRD-B15A cabinets to create spectacular high-resolution Micro LED displays.The powerful processor ""X1 for Crystal LED"" ensures extraordinarily realistic, finely-detailed images for an overwhelming visual experience on virtually any size and scale.The controller can accept a wide range of video input signals up to a maximum resolution of 3840 x 2160 pixels, with support for HDR, High Frame Rate and 3D.The 1.5U size rack mounting unit features 12x RJ45 output ports, 2x HDMI and 2x DisplayPort video inputs, 3D sync, genlock, network control and maintenance ports together with link input/output ports for interconnection with other ZRCT-300 display controllers to produce even larger displays.
The Cosmopolitan® is a ceiling or wall mounted electric screen.
MFR: Netgear, Inc
Qty: 1
Part #: GS105NA